Forums

:: Forums :: Introduction Forum :: Introduce Yourself
 
<< Previous thread | Next thread >>
Hi from Italy
Go to page   <<      
Moderators: chris, rainbow runner, Muck, Johnny Five, shiny red, mraryary, hypnoscope
Author Post
LurenZ
Sat Jan 30 2010, 08:36AM

Registered Member #3955
Joined: Wed Dec 02 2009, 03:16PM
Location: Avezzano, Abruzzo, Italia
Posts: 35
Thanked 2 times in 2 posts
Johnny Five wrote ...

Welcome to the forum friend! Very nice Runner, you have put in a lot of work there.
Could not understand what Shiny meant about the airbox until I got to the rear-view picture............wow!
I used to know a girl who looked like that, but not for long



And I know I too did that effect XD
Back to top
LurenZ
Sat Jan 30 2010, 08:37AM

Registered Member #3955
Joined: Wed Dec 02 2009, 03:16PM
Location: Avezzano, Abruzzo, Italia
Posts: 35
Thanked 2 times in 2 posts
Dom wrote ...

Wow great pictures b,down

That garage is cleannn lol!

Reeds lo;;ve

thanks :)... Well do not be fooled the low resolution, the garage is not as clean as you might imagine (the end is always a place for experiments XD)
Back to top
LurenZ
Tue Feb 09 2010, 04:46PM

Registered Member #3955
Joined: Wed Dec 02 2009, 03:16PM
Location: Avezzano, Abruzzo, Italia
Posts: 35
Thanked 2 times in 2 posts
hello guys, today I finally managed to carbides and the runner has to test it with the new power ... I had to assemble a jet from 330 (an absurd thing XD) and I mounted the rollers from 12.5gr in a temporary (I think that compared to the 11.5gr that mount with the Keihin Pwk 28 must be much better considering the increase excessive of torque) ... then, leaving a gap has slightly different since the size of Mikuni Tmx 35, but after passing the 5500/6000 rounds and joined the couple, also with a big one like me (1.84 cm x 80kg) trying to keep it low you can just, because the wheel tends to rise constantly ... for acceleration then we're two different worlds, now I feel about 5sec in the 0-100km/h, something that little one for a scooter as the Runner is something crazy ... now the only thing that scares me a bit is the consumers, but we shall see when it stops snowing XD ... who knows if the maximum speed is increased or not ... what do you say?? ciauz
Back to top
LurenZ
Sat Apr 10 2010, 03:29PM

Registered Member #3955
Joined: Wed Dec 02 2009, 03:16PM
Location: Avezzano, Abruzzo, Italia
Posts: 35
Thanked 2 times in 2 posts
Hello guys, long time after I completed the work on my Runner, I put both the new supply, both the reinforcing plate BMG and damper RRGS ... only that with the new configuration, the crankshaft has completely abandoned the original Piaggio me, going to break on the foot of the rod ... I replaced with a BGM Evolution 2 52mm, or your not rebranded Pm Tuning (BGM manufactures them), great crankshaft, really well done and balanced, something is lost in switching performance, but it takes plenty of both in recovery that the maximum speed, an increase of 300 rpm, so basically I was expecting worse ... I'm really satisfied with the overall performance of the medium, although I just tested here because of me is still very cold ... I am attaching some photos, this time in high resolution, I hope you like them :), good vision, ciauz

link

link

link

link

link

link

link

link
Back to top
rainbow runner
Sat Apr 10 2010, 03:36PM
GileraRunner.net Supporter - VIP Member


Registered Member #69
Joined: Wed Apr 26 2006, 07:03AM
Location: wigan
Posts: 3304
Thanked 69 times in 68 posts
thats one nice runner, :O and great detail in the photos |wd"

Back to top
LurenZ
Sat Apr 10 2010, 03:56PM

Registered Member #3955
Joined: Wed Dec 02 2009, 03:16PM
Location: Avezzano, Abruzzo, Italia
Posts: 35
Thanked 2 times in 2 posts
Thanks ;)
Back to top
Go to page   <<       

Jump:     Back to top

User Colour Key:
Head Administrator, Administrator, Forum Moderator, Member

Syndicate this thread: rss 0.92 Syndicate this thread: rss 2.0 Syndicate this thread: RDF
Powered by e107 Forum System uses forum thanks